Description | Daily | Weekly | Monthly |
---|---|---|---|
3/4 or 1.75 | $ 50 | $ 225 | $ 790 |
MP10 Controller | $ 100 | $ 450 | $ 1,575 |
12 Volt Driver/Compressor | $ 35 | $ 160 | $ 550 |
Environmental Equipment & Supply rents both micro purge pumps .75 and 1.75 inch. The Sample Pro Portable MicroPurge Pump uses a quick-change, one-piece bladder design. Compressed gas squeezes the outside of the bladder to force liquid out of the pump; there is no gas contact with the pumped water inside the bladder.
Either size pump comes in a kit with spare parts and an extra teflon bladder.
Squeeze type bladder pumps are supported by years of independent research that shows they provide unaltered samples for even the most sensitive parameters.
Groundwater enters the pump through the inlet in the upper, head section, then flows down into the bladder. The high inlet helps keep the pump from clogging if it is accidentally lowered into a sediment-filled sump.
Check valves with stainless steel seats and check balls are located at the inlet and outlet. Inlet screens are replaceable to help ensure proper sealing of the check valves in wells with high solids levels. The Sample Pro Pump is shipped in a heavy-duty tube with rubber end caps to help keep the pump clean and protected between uses.
The pump is disassembled by a 1/4 turn of the cap and body; no special tools are needed. The bladder pulls off for replacement. Both check valves are press-in, pull-out design, and use PTFE for the fluid inlet and stainless steel in the fluid discharge.
A MP10 controller and air compressor is required and is ordered separately. Don't forget to order your tubing.